The Bi-Loop antenna is a modification of the well-known BiQuad antenna. In this case, the squares are substituted by circular loops. In this case, there is no radical change in the principle of radiation of the antenna. We are still dealing with two elementary magnetic dipoles connected in parallel, only with a modified loop geometry, instead of a square - a circle. At the same time, the antenna aperture and, accordingly, the gain of such an antenna is even larger than that of a BiQuad, but not by much, only a fraction of a decibel. Yes, and making circular loops is much easier. It is enough to bend a circle of the desired diameter and not take the trouble in measuring the sides and diagonals of the square.
This calculator is different from the counterparts. This calculator is based on the ANSYS HFSS computer model, while the analogues use fixed dimensions in multiples of the wavelength (λ, λ/8, etc.). As the computer model shows, the circumference of the loop "C" is several percent less than the wavelength in free space. The same applies to the distance between the loops and the reflector "h". The antenna has an input impedance of 50 ohms and an estimated gain of 10.5 dBi.
Schematic representation of the antenna:

Javascript source code:
Copyright ©2015 - 3G-Aerial
Limitations and features of antenna calculations
Antenna characteristics set (click on the desired image to enlarge):
![]() |
![]() |
![]() |
![]() |
| Input impedance | VSWR | Gain dBi | Radiation pattern |
![]() |
![]() |
![]() |
![]() |
| Input impedance | VSWR | Gain dBi | Radiation pattern |
As you can see, in the range of 2100 MHz, the VSWR reaches 3 with satisfactory other characteristics of the antenna. In addition, we should not forget that the antenna needs a balun. This is usually neglected, which degrades the overall performance of the antenna.
Don't forget about antenna polarization. In the diagram, the antenna has a vertical polarization. Mounting features differ little from the BiQuad antenna. The gap at the connection point must be made as small as possible, preferably no more than the diameter of the wire. On UHF range, where the wire diameter can be more than 10 mm, it can be collected from several parallel wires of a smaller diameter. Along the edges of the reflector, you can make lips by analogy with the Marshall's antenna (which, it is worth noting, does not use a balun). This somewhat reduces the side lobes of the antenna radiation pattern.
Antenna gain can be increased by array stacking several Bi-loop antennas:
Similar calculators:
- Modern BiQuad antenna online calculator;
- BiQuad antenna T.Marshall's design calculator;
- Double Bi-Quad antenna online calculator;


















The site has comments on social networks, which have much more opportunities for communication.